Instruction For Use 1 CLEAN Clean up the surface thoroughly making sure that there is no dust Wait the surface DRY completely before the installation please be two people working together the width of the update a person is difficult to complete 2 Measure Cut Cut the film to the desired size through the grid lines It is suggested to leave 2 3cm margins at each side for later adjustment 3 Apply one from the side peel off the backing and applying the film to the surface inch by inch do not remove the entire backing at once 4 Flatten While applying the film use a cloth a squeegee or a card to remove the air bubbles or bump areas 5 Enjoy Trim off the margins enjoy your new gorgeous top surface Notes Make sure that the surface is clean and flat Heavily textured surfaces may affect the adhesive glue effect Using a smooth surface is therefore strongly recommended Be careful when working with the utility knife in order to avoid Color tones can vary due to lighting in the room pictures on wall for reference only Please buy enough rolls at a time to make sure they come from the same batch to avoid color difference